****** - Verified Buyer
4.5
We cut it down from the 36” length to 31” to fit our tiny shower. It was incredibly easy to do.Easy to install. No screws required. It uses double sided adhesive tape.We will caulk the sides to seal it off as an extra precautionary measure but we’ve used the shower multiple times without doing so and no leaks.Only the top portion of the door is on a track. The bottom part is not connected to the track. It merely sits inside it, so just be carful when opening and closing the door so that the bottom stays within the track. Best to pull from top and middle to help it glide.I’d recommend wiping off the inside of the door before marching it open in order to get rid of extra moisture so that mold/mildew does not build up.arrived on time , fit needed to be trimmed a1/4" no big deal trim both top and bottom pieces, installation was pretty straight forward . the button to hold the door closed is attached to the top rail . remove that before installing top rail .for the money it's just ok . i gave 4 stars but would have given 3.5 if that were an option . it works as advertised a little flimsy , need to attach the pleats to the wall end as it would pop out so a couple screws where the brass rivits are and on the handle i had to squeeze in some adhesive caulk to keep it well attached to the rail . it believe this will work fine . if you have a shower in your rv that has the curved bar on top with curtains this will cut down on the room you have in your shower by 2 or 3 " . had not thought of this when i bought and while standing in the shower it does feel a little more cramped in there but should work fine waiting for caulk to dry so i can take a shower . it looks nicer from the outside . much cleaner look and since my toilet is right next to the shower the curtian does not get in the way anymore . we'll see how long it lasts . make sure you clean all surfaces with acetone before applying the bottom and side pieces so the double stick tape adheres well and then be sure and caulk all edges inside and out ! good luck .UP DATE got to use shower today . with this shower door it does make the shower 2 to 3 " smaller . not a big deal but may have not bought if i had realized this before hand . Rv showers are small to begin with . next thing that's not quite right is the bottom channel hold water . it does not all drain out through the provided drain holes . about 1/6 " stays in the channel . they should have had the front a bit taller and sloping back into the shower pan . other then this it works and am happy with the look and partly happy with the function.Not sure if I received a return, but it had a lot of scuff marks on the rails and one of the adhesive tape squares on the top already had the paper removed. I would have returned if I had the time but needed to get it installed for an upcoming trip. I installed it myself with minimal skills, so I think anyone can do it. You definitely need to be gentle with opening and closing the curtain as it's pretty fragile and the bottom easily comes out of the track. It'll work for me, and I don't expect it to last a long time, but it will get me through the summer. You get what you pay for and for the price, it's fine.The accordion folded plastic is very thin. The adhesive is somewhat weak so be prepared to caulk and screw in the side panels. Not bad looking, just very thin, as mentioned.Easy install, convenient, it’s not top notch quality but it’s also not top quality money, works great with my 3’ rv bathtub, and best of all it’s American madeI like this shower door. I was tired of water running on the camper floor from the shower curtain. I also did not like the shower curtain clinging to me as I showered. The kids and shower curtain is a water disaster. This fixes all the splashed water issues.Installation. In theory the installation is pretty simple, however it took me about 2 hours total time to install. If I had to do this again it would probably take 45 minutes. The bottom and vertical pieces come with an adhesive strip that holds the parts in place, after everything is mounted caulk inside and outside of curtain tracks.Here are the basic steps for installation:1 cut if needed and Install the bottom track.2 install the vertical side track that holds the curtain. My shower does not have a liner so I had to spend some extra time deciding what to do where the tub lip and the wall meet as the vertical tracks for the shower curtain are not made for that situation. What I did to fix that was to fill the nearly ½ inch gap with a good quality silicone bath caulk.3 mount the other vertical piece.4 Cut if needed and mount the top track.5 The next important step is marking the latch location. I used a pencil to mark the area then visually checked if it lined up with the male part of the latch. Once it lined up I know where to drill the hole and mount.The curtain does not open and close easily so after installation is complete spray some silicone lubricant spray on the top track where the shower glides are, that makes a tremendous difference. The results are wonderful. Love the shower curtain. Will not go back to a curtain.Notes- if your shower is smaller than the width you buy it is easy to cut to fit with a hacksaw or saws all. Be sure and measure twice and cut once, probably difficult to obtain replacement part if length is cut wrong.To avoid mildew leave shower curtain mostly open while camping and close before transporting, want the curtain to dry as much as possible to avoid issues.This door by far, beats the blowing shower curtains. I had to do some framing because my opening was 40". After my framing & sealing up, this door fits like a glove. I have to sit on a seat that I made in my camper, (Left leg Amputee). This door works FANTASTIC. I LOVE IT. It's so much better than a BLOWING, AGGRAVATING, SHOWER CURTAIN. So far so good.I installed this shower door in my box truck tiny house shower. When I first installed it, I noticed it was below my head. Then I realized it was for a bathtub! LOL So, I took it out and built a wall high enough to make the door go to the ceiling. Caulked and sealed it. It has worked amazingly! My shower is 47" wide so I only had to cut 1". It was super easy to install.So far a very easy install. Cut the top and bottom rails to fit my 31.25 inch opening. Height was no issue and came in just under the shower rod I left in place. Two way tape holds well but put generous amounts of silicone caulking on the inside of the bottom and sides. Looks like water will be able to leak out of bottom sides of lower track if you do not seal it. Ensure you have the bottom rail with the drain holes facing the inside of shower.Spray lubricant into top rail after install and curtain will slide easily. Line up the "button receiver" (I call it) with hole to secure door when closed. Mine was bowed a bit on top and bottom but may be do to storage and shipping.Awesome product. Easy installation. Just make sure you install the verticle uprights, one that also has the accordion door attached to it with the notches up and not down, to accommodate the aluminum rail that holds the door suspended for ease of sliding. The instructions are not clear on this. Also the rail on the bottom of the door needs to be installed with the drain holes in toward the tub. Remember to measure twice and cut once. The plastic rails can be cut with a circular saw and the aluminum rail with a hacksaw. Great product!!Easy to install. Good fit and finish. Works 100% to my satisfaction. Should have done it long ago.Note close up picture of the fabric shows its touch of quality.The item does not include any installation instructions. Not even basic pictures on how to install, or what sealants to use. Also does not come with stainless steel screw to mount the door pin. Door is made of a paper thin plastic .The eyelet came off from the fabric during installation and doesn’t slide very well. Spent time installing it otherwise I could have returned it. The idea is good but It could use a more stronger and better fabric.
